Sunwave SRC-3810 Manuel d'utilisateur télécharger pdf (Page 21)

Device Menu

an IR signal to the desired device. Both the device and

the IR-extender must be set to the same RF address to

operate properly. To set the RF address:

1. Press

or to select RF ADDR

2. Press Ok

3. Select either IR to operate in

the IR mode or an RF address

(0-9) for the IR-extender.

4. If an RF address is selected on

the SRC-3815, set the IR-

extender (SEL-6000) to the

same RF address by adjusting

the ADDRESS wheel on the rear

panel as needed (0~9).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 57 58

Pas de commentaire

Sunwave SRC-3810 Manuel d'utilisateur Page 21